The first questions we ask
When someone in Stourport-on-Severn rings about a new fence, we start with simple questions. Which boundary is it, who owns it, and what is on the other side? A neighbour's garden, a road, a footpath and a field all lead to different answers. We also ask whether the house is old, in a protected area or part of a recent development, because any of these may bring in extra conditions.
None of this is legal advice, and we are fencers rather than planners. What we can do is point you to the right place, which is usually the local council, and make sure you ask the right question. Having a photo and a rough sketch of the boundary makes the conversation much quicker, for them and for us.
How we measure on site
On site we measure from the ground on the side the fence stands on, to the highest point of the finished job. That includes the gravel board, the panel, any trellis and the post tops if they stand above. If the ground slopes, we note the highest and lowest points, because the tallest section is the one that matters. We write the numbers down so the plan is clear before any posts go in.
Because we know the Stourport-on-Severn area well, we know that gardens vary a lot in layout and level. Some are flat and simple. Others have steps, banks or retaining edges that change the effective height of a fence. In those cases we often suggest stepping the panels or using a lower fence on top of the existing level, so the finished height stays sensible.
The usual exceptions to keep in mind
The general rule of thumb has exceptions. Conservation areas, listed buildings and conditions attached to a planning permission can all change what is allowed. Boundaries beside a road or footpath are normally held to the lower figure. Some properties have restrictions on the front boundary even where the back is free. Always check with the council rather than relying on what neighbouring fences look like.
If a neighbour is involved, a friendly word before the work starts goes a long way, and your deeds can show who is responsible for each boundary. A fence that is within the rules, built straight with firm posts and agreed with the people either side, is the aim. If anything is unclear, take advice before spending money on materials.
Quick tips
- Write down the tallest point of the finished fence, including gravel board, trellis and post tops, before you commit to an order.
- Take a photo of each boundary and note what lies on the other side, whether garden, road, footpath or open land.
- Contact the council first if your home is old, in a protected area or part of a newer development.
- Agree the plan with neighbours before work begins, and keep any written notes for later.
If you are in Stourport-on-Severn or nearby and want a straight answer on fence height, call us or send a photo with the fence location. We know DY13 well and also work in Bewdley and Kidderminster. No pressure, just honest advice.
Frequently asked questions
What should I have ready before ringing about a new fence?
A photo and a rough sketch of the boundary make the conversation quicker. Know which boundary it is, who owns it, and what lies on the other side, whether a neighbour, road, footpath or field, as each can lead to a different answer.
How do you measure fence height on site in Stourport-on-Severn?
We measure from the ground on the side the fence stands on to the highest point of the finished job, including gravel board, panel, trellis and post tops. On a slope we note the highest and lowest points, because the tallest section is what matters.
Fencing contractors in Stourport-on-Severn · All advice guides